4 ± 0.7 nm. Figure 1b shows the X-ray diffraction (XRD) patterns of the Ag2S nanocrystals, and all the diffraction
peaks can be indexed to the monoclinic Ag2S phase (JCPDS card: no. 14-0072). Figure 1 TEM image and XRD patterns and standard diffraction lines of Ag 2 S. TEM image of resultant Ag2S nanocrystals (a) and XRD patterns of Ag2S nanocrystals and standard diffraction lines of monoclinic Ag2S (b). The electrically bistable devices were fabricated on glass substrates pre-coated with an indium-tin-oxide (ITO) anode, which were alternately cleaned by deionized water, acetone, and ethanol in an ultrasonic environment. Afterwards, the poly(3,4-ethylenedioxythiophene)/poly-(styrene-sulfonate) (PEDOT/PSS) was spin-coated onto the substrate and was annealed ACP-196 datasheet at 150°C for 20 min, check details which could smooth the ITO surface and improved the device stability by hindering oxygen and indium diffusion through the anode. The PVK and Ag2S nanocrystals were mixed and dissolved in chlorobenzene solution with a mass ratio of 1:1. The solution would further form the active layer by the spin-coating method. Finally, a top Al electrode layer of 200 nm thickness was deposited onto the top surface by thermal evaporation under the vacuum of about 1 × 10−6 torr.
Results and discussion The I-V characteristics of the devices with a structure of ITO/PEDOT:PSS/Ag2S:PVK/Al under different sweeping voltages are shown FER in Figure 2. The voltage scan sweeps −5 to 5, −10 to 10, and −15 to 15 V, respectively. All the I-V curves of the devices under different sweeping voltages exhibit a typical electrical bistability. The magnitude of the I-V hysteresis increases
with increasing maximum sweeping voltages, and the ON/OFF current ratio of the device can approach 104. Herein, we take the I-V result under the sweeping voltage from −15 to 15 V as an example to describe the electrical hysteresis process. When the sweeping voltage exceeds a certain threshold, namely V on (about 8 V), the current increases rapidly, which indicates that the conducting state transforms from OFF to ON state. When the sweeping voltage scans from 0 to −15 V, the current reaches its maximum at a certain voltage (about −6 V), which is labeled as V off (the voltage region where the NDR effect takes place), and then decreases quickly with the increasing reverse voltage, which is a typical NDR behavior. As a result, the conducting state changes from ON to OFF state. Considering that there is no obvious hysteresis observed in the device using only PVK as active layer we suggest that the Ag2S nanocrystals play a significant role in the electrical bistability. Furthermore, it can be seen in Figure 2 that the absolute value of V off increases with the increasing magnitude of the sweeping voltage, indicating that there might be a certain connection between the NDR effect and the sweeping voltages.